Obsolete
Alternative Click Here
The Menvier300 is a control unit for a hybrid wired/wirefree alarm system intended for domestic, commercial or industrial use.
The control unit comprises a steel case containing the control unit PCB (printed circuit board), power supply and space for up to two backup batteries.
The control unit PCB provides terminals for a single bus. The bus allows you to connect up to 45 peripheral devices using standard 7/0.2mm four wire alarm cable. The peripheral devices can be any mixture of keypads or zone expanders (for wireless or wired detectors).
The control unit PCB also provides a range of connectors for outputs, communicators, and up to 10 FSL (Fully Supervised Loop) or five 4-wire CC (Closed Circuit) zones.
The Menvier300 Release 4 uses i-kp01 keypads with software revision 3.02 and above. The keypads allow end users to set and unset the system, and the installer to configure the control unit. The i-kp01 keypad also contains an integral proximity tag reader, allowing end users to control the system without having to remember access codes.
A range of wireless peripherals is available for operation with the wireless expanders. These include a door contact/universal transmitter, a passive infra red detector, smoke detector, external siren, 4 button remote control, radio Hold Up Device and remote radio keypad.
This control unit is designed and approved to be used as part of a Security Grade 3 system. The control unit is also approved to operate as part of a Security Grade 2 system. If you install any radio devices this will limit approval to Security Grade 2 in the Ward in which they are used.
Communications
The Menvier300 provides sockets for an add-on communication module. The available modules are:
i-sd02 (ATS2)
