Obsolete
Alternative Click Here
The Menvier100 is a control unit for a hybrid wired/wirefree alarm system intended for domestic, commercial or industrial use.
The control unit comprises a steel case containing the control unit PCB (printed circuit board), power supply and space for a backup battery.
The control unit PCB provides terminals for a single bus. The bus allows you to connect up to 45 peripheral devices using standard 7/0.2mm four wire alarm cable. The peripheral devices can be any mixture of keypads or zone expanders (for wireless or wired detectors).
The control unit PCB also provides a range of connectors for outputs, communicators, and up to 10 FSL (Fully Supervised Loop) or five 4-wire CC (Closed Circuit) zones.
The Menvier100 Release 4 uses i-kp01 keypads with software revision 3.02 and above. The keypads allow end users to set and unset the system, and the installer to configure the control unit. The i-kp01 keypad also contains an integral proximity tag reader, allowing end users to control the system without having to remember access codes.
A range of wireless peripherals is available for operation with the wireless expanders. These include a door contact/universal transmitter, a passive infra red detector, smoke detector, external siren, 4 button remote control, radio Hold Up Device and remote radio keypad.
This control unit is designed and approved to be used as part of a Security Grade 3 system. The control unit is also approved to operate as part of a Security Grade 2 system. If you install any radio devices this will limit approval to Security Grade 2 in the Ward in which they are used.
Communications
The Menvier100 provides sockets for an add-on communication module. The available modules are:
|
i-sd02 (ATS2) |
A speech dialler and public switched telephone network (PSTN) module that allows the control unit to send recorded speech messages and report alarm information using standard protocols such as Fast Format, SIA and Contact ID. This module also allows remote maintenance. |
|
i-dig02 (ATS2) |
A switched telephone network (PSTN) module that allows the control unit to report alarm information using standard protocols such as Fast Format, SIA and Contact ID. This module also allows remote maintenance. |
|
i-gsm02 (ATS2) |
A GSM module that allows alarm reporting, speech messaging and SMS text messaging over the mobile phone network. |
The control unit also provides outputs that can be used to fit a
