Honeywell Galaxy Dimension MAX3 single door control unit N/C

Introduction
The MAX3 is a proximity reader access control device for a single door, which can also be used for setting and
unsetting of your alarm control panel. The MAX3 can be configured in one of two ways:
Standalone
In this configuration the MAX3 can be used for either door control or alarm system set/unset control, by either
connecting the internal relay output to a door lock, external relay or into the keyswitch zone of the alarm system.
When in standalone mode the MAX3 is programmed and operated using the MAX3 proximity cards or tags.
On-line
The MAX3 can operate in on-line mode, with the Galaxy 8-512 control panel range, as a completely integrated
module on the system. In this configuration the MAX3 can be used for both door control and alarm system set/unset
control with complete user traceability stored within the Galaxy control panel.
For detailed instructions on how to programme the MAX3 onto the system in on-line mode refer to section 63.2 of the
Galaxy Programming Manual IP1-0030.
The proximity cards and tags each have unique ID numbers and must be identified to the MAX3 before being used to
operate the system. The MAX3 memory can store up to 1000 ID numbers, including at least three reserved for
Masters. Once programmed, the ID number of the tags and cards are stored indefinitely in the MAX3 memory until
voided (removed) or erased. Removing power from the MAX3 does not erase the programming memory.
On-line
The MAX3 can operate in on-line mode, with the Galaxy 8-512 control panel range, as a completely integrated
module on the system. In this configuration the MAX3 can be used for both door control and alarm system set/unset
control with complete user traceability stored within the Galaxy control panel.

Obsolete - Alternative Click Here